Welcome to Australia's only Vintage Radio and Television discussion forums. You are not logged in. Please log in below, apply for an account or retrieve your password.
Australian Vintage Radio Forums
  Home  ·  About Us  ·  Discussion Forums  ·  Glossary  ·  Outside Links  ·  Policies  ·  Services Directory  ·  Safety Warnings  ·  Tutorials

Cabinet Repairs

Forum home - Go back to Cabinet Repairs

 The best brush to buy for clear coat application of shellac ,varnish, etc
« Back · 1 · Next »
 Return to top of page · Post #: 1 · Written at 1:13:51 PM on 15 April 2019.
Vintage Pete's avatar
 Location: Cromer, NSW
 Member since 1 May 2016
 Member #: 1919
 Postcount: 864

The best way to apply clear coats is a good spray gun, But if you have time there is no reason it can't be done with the right brush because all coats will be rubbed back and polished no matter what tool you used to put the clear on with, The key is light coats . As a general rule it will take 8 to 10 coats to achieve a flat plane that is full ,,Being full and flat so that you can polished down on it. it's the same in either of the traditional finishes of shellac ,varnish , nitro.
So if your using a brush , buy a paddle brush made by Holcraft and it can be bought from Art stores.
The reason it's so good is , its wide, it puts light coats on , it leaves minimal lines to be polished out.... You don't use it like a brush , you put it on in one long swoop and then do another long swoop so you only get one line .
If your trying to fill the grain and achieve a flat plane then paint the clear coats on across the grain not with the grain.

I highly recommend this paddle for anyone who is doing the brush method.

http://riotstores.com.au/item/174801-holcroft-paddle.html


All the best Pete


 
 Return to top of page · Post #: 2 · Written at 7:32:33 PM on 16 April 2019.
GTC's avatar
 GTC
 Location: Sydney, NSW
 Member since 28 January 2011
 Member #: 823
 Postcount: 5017

Thanks for that tip, Pete. I intend to do some shellacking between now and September.


 
« Back · 1 · Next »
 You need to be a member to post comments on this forum.

Sign In

Username:
Password:
 Keep me logged in.
Do not tick box on a computer with public access.